Legacy-audio Studio HD Manual de usuario

Owners Manual For The Studio HD Loudspeaker System

10 Ideally the loudspeaker would be among the first components selected when assembling a play-back system. This would allow the user to choose an am

11 How much power will your new speakers need? That ultimately depends on your listening environment and musical tastes. As little as five watts per

12 When an amplifier is unable to fulfill your loudspeakers demands, a damaging harmonic spike may be leaked to the high frequency drivers. Anothe

13 The Terminal Plate At the rear of each of your loudspeakers you will find a terminal plate housing two rows of jumpered binding posts. The upper r

14 To facilitate proper set-up of your speakers in a variety of room situations, we have included several heavy duty toggle switches on the terminal

15 System Type: 2 drivers, 2 way Low Frequency Alignment: B4 Reflex Frequency Response: 41Hz – 30 kHz Impedance: 4 O

16 Legacy Audio 3023 E. Sangamon Ave. Springfield, IL 62702 USA 800-283-4644 States that this product is in conformity with the with the essent

17 Notes:

18 ©2015 Legacy Audio 3023 E Sangamon Ave. Springfield, IL 62702 Phone: 800-283-4644 Fax: 217-544-1483

2 Registration Owners Record 3 The Cabinetry / Our Commitment 4 Warranty 5 Setup Unpackin

3 The serial number is located on the rear of the unit. Record this number in the space provided below. Refer to this when calling your dealer rega

4 Handcrafted Beneath the surface of Studio HD’s elegant exterior lies rigid MDF construction. Interlocking joinery maximizes the strength of the cab

5 Legacy Audio supports its customers and products with pride. We cheerfully warrant our loud-speaker products we manufacture from defects in materi

6 Your new speaker system has been very carefully packaged to insure that it travels to you safely. Each speaker is protected by a double-wall outer

7 To allow more flexibility in seating arrangements, your Legacy loudspeaker is designed for broad lateral coverage. Optimal listener position is act

8 The ideal conductor would have negligible resistance, inductance and capacitance. The table below shows how a few actual speaker cables measure up.

9 What about phase shift due to frequency dependent travel times down the speaker cable? Measurements show that 100 Hz waves will be delayed about 20